The image below requires the Whip!
driver from Autodesk to be installed.
Click to install the driver now.
Once installed, you may zoom, pan, plot or save this
detail by clicking on the right mouse button to active the menu.
You may also drag and drop it into an AutoCAD
drawing. To do this, hold down the CONTROL key while dragging and drop it into
AutoCAD R14 via the INSERT command, or hold down both the SHIFT and CONTROL keys to
perform an OPEN command.
INSTALLATION INSTRUCTIONS FOR LOW VOLTAGE UP AND ACCENT
LIGHTS
FOR USE ONLY WITH LOW VOLTAGE LANDSCAPE POWER UNITS THAT DO NOT
EXCEED 25 AMPS, 15 VOLT MAX.
WARNING: Fixture must be
installed in accordance with local codes of the National Electrical Code (NEC).
Failure to do so may result in serious injury and/or damage to the fixture.
SAFETY WARNING: Fixture can become very hot depending upon the lamp
wattage used. Lens and metal around the lamp can become hot enough to blister
hands. Particular care should be take no to locate fixtures where small children can
reach them if high wattage lamps are used.
LUMINARIES ARE NOT TO BE INSTALLED WITHIN 10 FT. (3.05 M) OF A POOL OR SPA.
TOOLS REQUIRED FOR INSTALLATION:
Phillips Screwdriver
Wire Stripper
To prevent electrical shock, disconnect transformer from electrical supply before
installation or service.
Run wire from fixture through the mounting hole in top of ground spike (see figure).
Thread fixture into threaded hole in ground spike (see figure).
Place spike in desired position and insert into ground until flange of spike is flush to
the ground (see figure).
Strip the two (2) leads from the fixture wire. Using the two (2) silicone filled
safety connectors (supplied) connect the leads from the fixture to the main supply cable
leads (see figure). NOTE: Fixtures are supplied with 36" of 18-2 cable pigtail for
secure connection to the main supply cable. Always coil extra cable not used below
fixture for future relocation if desired.
Aim fixture to desired angle. Lock into place by tightening phillips heads screw
on adjustable knuckle (see figure). NOTE: Avoid aiming fixture directly upward. Whenever possible, set
at angle to prevent rain or irrigation water from setting on lens.
IMPORTANT SAFETY INSTRUCTIONS:
LIGHTED LAMP IS HOT!!
WARNING: TO REDUCE THE RISK OF FIRE, OR INJURY TO PERSONS:
Turn off / unplug and allow to cool before replacing lamp.
Lamps get HOT quickly! Contact only switch/plug when turning on.
Do not touch hot lens, guard or enclosures.
Keep lamp away from materials that may burn.
Do not touch the lamp at any time. Use a soft cloth. Oil from skin
may damage lamp.
Do not operate luminare fitting with a missing or damaged shield (cover).
SAVE THESE INSTRUCTIONS
LAMP INSTALLATION / REPLACEMENT:
CAUTION: Do not exceed maximum wattage marked on fixture label.
To prevent electrical shock, disconnect transformer from electrical supply before
service.
Loosen screw(s) from shroud.
Remove shroud to expose lamp.
Replace lamp with correct wattage and type of lamp marked on fixture label. NOTE: DO NOT touch Halogen lamp with bare hands. Always use the
plastic bag (if available) to handle the lamp.
to install the driver now.